16
Setting the AUTO-ON TIMER (cont’d)
5) All of the settings are now registered.
TURN
THE UNIT “OFF” USING THE I/O SWITCH.
6) To set the
AUTO-ON
timer, the unit must be
turned to the
“off”
position (non-operational).
7) Press the
TIMER-ON
key pad to initiate the
AUTO-ON
time sequence.
Fig. 32.
The display
window will indicate
TIMER-ON
and the word
ON
will flash for 5 seconds. Press the or key
to select the desired
AUTO-ON
start time.
Fig. 32a.
key pad will decrease the
AUTO-TIMED
setting in 10 minute increments.
keypad will increase the
AUTO-TIMED
setting in 10 minute increments.
When the desired time is established, (the time
will flash in the display window) press the
CLOCK
key pad to register the
AUTO TIMER-
ON
program. The word
ON
will stop flashing and
remain “on”
(TIMER ON)
indicating the program
is set. The time of day clock setting will
immediately revert back in the display window.
IMPORTANT: The desired AUTO-ON time must
be registered within a 5 second period (after
pressing the TIMER-ON key pad) otherwise the
selected time will not register and the system
will automatically revert back to the regular
“time of day” clock setting. If this occurs, you
must repeat step 7 again.
The unit will start automatically when the specified
AUTO-ON
time is achieved on the time of day clock
(the
“TIMER ON”
prompt will disappear from the
display window). To cancel or override the
AUTO-
TIMED
program, simply turn on the unit before the
AUTO-ON
time is scheduled to operate (the
“TIMER
ON”
prompt will disappear from the display window).
You can varify the
AUTO-ON
time selection anytime
(prior to the program starting) by pressing the
TIMER-ON
key pad. The time you selected will
appear (flash) temporarily (replacing the time of day)
for approximately 5 seconds.
Water Full
Cool/Heat/Dry
I/O
MODE
ON
OFF
SWING
TIMER
CLOCK
FAN
12:00
TIMER
ON
TEMP./CLOCK
ADJ.
Fig. 32
Water Full
Cool/Heat/Dry
I/O
MODE
ON
OFF
SWING
TIMER
CLOCK
FAN
12:00
TIMER
ON
TEMP./CLOCK
ADJ.
Fig. 32a
