OPERATING INSTRUCTIONS
OPERATION
To avoid vibration, the cabinet must be set level.This is accomplished by adjusting the (2)
front leveling legs located under the freezer cabinet.
To start the freezer, turn the temperature control to the position corresponding to the
desired cooling.
0 = No Cooling
1= Minimum Cooling
3, 4 = Medium Cooling
MAX= Maximum Cooling
The freezer temperature will vary depending on the quantity of the food stored and on the
frequency with which the door is opened.
6
1
Maximum cooling
DEFROSTING
INSTRUCTIONS
Defrost and clean your freezer when frost has built up to about 1 1/4”(6mm) thickness.
Complete defrosting and cleaning should be done at least once a year. In high humidity
areas, a freezer may need more frequent defrosting and cleaning.
IMPORTANT: Do not use an ice pick, knife or other
sharp-pointed tool to defrost freezer. Damage can occur.
1) Turn temperature control to ‘0’(off) and unplug power
cord.
2) Remove all frozen food.Wrap frozen food in
several layers of newspaper and cover with a blanket.
Food will say frozen for several hours OR store frozen
food in a cooler, additional refrigerator-freezer or in a
cool area.
3) Place pans of hot water in freezer with door open
to speed melting. Directing air from an electric fan into
freezer will also help. Do not place fan in freezer.
4) Remove frost.
5) Wipe water from walls and bottom of freezer with a
towel or sponge.
6) Wash inside walls.
7) Rinse and dry thoroughly.
8) Replace all frozen food.
9) Plug in power cord and refer to “Operation.”
DOOR REVERSAL
INSTRUCTIONS
To avoid personal injury to yourself and/or property,
we recommend someone assist you during the door
reversal process.
CAUTION
1) To access the lower hinge assembly,
tilt back the freezer cabinet or lay the
freezer on its back. (Fig.A)
2) Remove both leveling legs located
at the front of the
cabinet.
3) Remove the screws holding the
lower hinge assembly to the cabinet.
4) Remove the main door assembly
from the freezer
cabinet (lift door slightly and pull down-
ward).
5) Using a f at head
screwdriver, remove the main door top
hinge pin.(Fig.B)
6) Re-install the main door top hinge
pin on the opposite side of the cabinet.
7a) Remove the door plug and door
bushing located on the top of the main
door.
7b) Interchange their positions (eg.door
plug right side, door bushing left side).
8) Re-install main door assembly on
cabinet.
9) Remove door bushing (bottom door)
and install on opposite side.
10) Re-install the lower hinge assembly
on the opposite side.
11) Make sure the door assembly is
properly aligned on the cabinet before
tightening lower hinge screws.
12) Re-install both leveling legs. The
process is now complete.
2