Installation Instructions
NOTES:
• This appliance is intended for
FREE-STANDING INSTALLATION ONLY
,
and is NOT intended to be built-in.
• Before connecting this appliance to electrical power supply, leave it to
stand for approx. 24 hours, which will reduce the possibility of
malfunction in the cooling system due to transport handling.
• This appliance is approved for
INDOOR USE ONLY
and is NOT
intended for outdoor operation.
IMPORTANT
Install this appliance in an area where the ambient temperature is
between 55°F (13°C) and 90°F (32°C). If the temperature around the
appliance is too low or high, cooling ability may be affected.
DOOR REVERSAL
INSTRUCTIONS
The door of the refrigerator can be hinged on either side so that the direc-
tion it opens in can be changed to suit the place of installation. Refer to
the disassembly diagram and change the door hinges according to the
following steps:
IMPORTANT
Before you begin, unplug refrigerator or disconnect power.
Remove food and any adjustable door or utility bins from doors.
1.
Remove the hinge cap by twisting it off.
2.
Remove the upper hexagonal head screws. The freezer door can now
be removed.
3.
Remove the middle hexagonal head screws. The refrigerator door can
now be removed.
4.
Remove the right side leg, line it up with holes on the other side and
attach it.
5.
Remove the left side leg, line it up with holes on the other side and
attach it.
6.
Line up and attach the bottom hinge to the other side of the cabinet.
7.
Remove the upper hinge hole plug and insert them in the holes from
which the screws were removed in Step 2.
8.
Remove the middle hinge plastic cover and remount it to cover the
holes from which the screws were removed in Step 3.
9.
Remove the door hole plug from the top of each door using a
screwdriver and insert in the hole on the opposite side of each door.
10.
Attach the refrigerator door to the bottom hinge.
11.
Rotate the middle hinge 180 degrees. Attach it to the refrigerator door
and secure it with a screw. (Do not tighten the screw completely.)
12
. Attach the upper hinge to the freezer door. Attach the freezer to the
middle hinge and use the screw to attach the upper hinge. (Do not
tighten the screw completely.)
13.
The direction in which the doors open has now been changed;
however, the following points should be checked:
A)
Make sure both doors are on straight.
B)
Make sure that there is no space between the door gasket and
the refrigerator unit itself when the doors are closed.
C)
Make sure that the gasket on the hinged side is not caught
between the door and the unit when the door is opened or
closed. (If the door is forced closed when the gasket is caught,
the gasket may be damaged.)
9
0
9
0
0
5
5
4
6
0
8
11
3
1
2 12
7
3
