10
TROUBLESHOOTING
Appliance will not operate
• Plug is not fully inserted into the wall outlet
• Blown fuse or circuit breaker
• Ambient humidity is lower than the set humidity
• Bucket is full or is not in the proper position
Insuffi cient dehumidifying
• Air
fi lter is dirty
• Blocked air fl ow
• Appliance size is too small for application
• Ambient humidity is lower than the set humidity
Noise
• Air
fi lter is dirty
• Bucket is not in proper position
• Floor surface is not level
Odors
• Formation of mold or mildew on internal wet
surfaces
• Place an algaecide tablet in the water bucket
Water on fl oor
• Hose connection is loose
• Drain cover has been removed
Frost build up
• When ambient temperature is below 5
°
C (41
°
F)
frost may form
• Switch the appliance to fan only mode until the
frost melts
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and on, the
user is encouraged to try to correct the interference
by one or more of the following measures:
1. Reorient or relocate the receiving antenna
2. Increase the separation between the equipment
and receiver
3. Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected
4. Consult the dealer or an experienced radio/TV
technician for help
Changes or modifi cations not approved by the
party responsible for FCC and Industry Canada
compliance could void the user’s authority to
operate the equipment. This appliance complies
with Part 15 of the FCC Rules and license-exempt
RSS standards.
Operation is subject to the following conditions:
1. This device may not cause interference.
2. This device must accept any interference
received, including interference that may cause
undesired operation.
This equipment complies with FCC RF and IC
RSS-102 radiation exposure limits set forth for an
uncontrolled environment. This equipment should
be installed and operated with minimum distance
20cm(8 inches) between the radiator and your
body.
This device complies with RSS-247 of Industry
Canada. Operation is subject to the condition that
this device does not cause harmful interference.
This device complies with Canadian CAN ICES-3
(B) / NMB-3 (B)
This device contains:
FCC ID: 2ADQOMDNA21
IC: 12575A-MDNA21
FCC WIRELESS REQUIREMENTS