Operating Instructions
10
CHANGING THE BATTERIES ON THE REMOTE
Protect the remote control from high temperatures, and keep it away from
radiation exposure.
Keep the control panel receiver out of direct sunlight.
If the remote control will not be used for extended periods of time
(vacations, etc.) batteries should be removed.
Do not mix old and new batteries.
Do not mix alkaline,standard (carbon-zinc), or rechargeable (ni-cad,
This Class B digital apparatus complies with the Canadian ICES-003
The remote operates within a range of 8 meters (26 ft.) from the receiver
located inside the main unit. Any obstruction between the receiver and
remote may cause signal interference, limiting the ability to program
the main unit.
To operate the hand held remote control will require two “AAA” Alkaline batteries (included).
Batteries should be replaced when:
a)
No signal (beep) is heard when attempting to program the main unit.
b)
The main unit does not respond to a command issued by the remote control.
Battery replacement:
1)
Slide the rear cover on the remote in the direction of the arrow. Continue pulling (gently) until
the cover separates completely from the unit.
2)
Insert (2) batteries (AAA) following the same orientation (polarity) depicted inside the battery
chamber (+/-).
3)
Re-install rear cover.
4)
If the remote control will not be used for extended periods of time (vacations etc.), batteries
should be removed.
ni-mh,etc) batteries.
standard. CAN ICES-3(B_)
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
1) Reorient or relocate the receiving antenna
2) Increase the separation between the equipment and receiver
3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
4) Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not approved by the party responsible for FCC compliance could void the
user’s authority to operate the equipment.
This appliance complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that may cause
undesired operation.
