Operating In
s
tructions
USING THE REMOTE
CONTROL
Location of the remote controller.
•
Use the remote controller within a distance of 8
meters from the appliance, pointing it towards
the receiver. Reception is confirmed by a beep.
CAUTION
•
The air conditioner will not operate if curtains, doors or other
materials block the signals from the remote controller to the
indoor unit.
•
Prevent any liquid from falling into the remote controller. Do not
expose the remote controller to direct sunlight or heat.
•
If the infrared signal receiver on the indoor unit is exposed to
direct sunlight, the air conditioner may not function properly. Use
curtains to prevent the sunlight from falling on the receiver.
•
If other electrical appliances react to the remote controller, either
move these appliances or call the service depot.
8
While the Air Conditioner is on (Auto-Off):
1)
Press the
Auto-T
imer button twice and the
adjacent
Auto-Of
f
indicator
light
will
illuminate.
2)
Use the
Temp/T
imer control cursors to select a
delayed
Of
f time of
up
to 24
hours.
3)
The time you
selected
will
appear
in the LED
display
. The Auto On
and
Auto
Of
f timer can
operate
during
the same
program
by
defining
the
Auto-Of
f
p
arameters
immediately
af
ter the Auto On
parameters.The
Auto-T
imer may be
cancelled
at any time by
turning
the unit
On/Off.
For example,if you want to let the machine on one hour later and last
for one hour and then stop,set auto on “1” and auto off “2”.
/
E
T
N
W N
I
A
8m
AUTO-TIMER:
Used to
initiate
the Auto On/ Auto
Of
f
timer.
While the Air Conditioner is off (Auto-On):
1)
Press the
Auto-T
imer button once and the
adjacent
Auto-On
indicator
light
will
illuminate.
2)
Use the
Temp/T
imer control cursors to select a
delayed
On time
of
up to 24 hours.
3)
Select the
appropriate
mode
under
which
you want the unit to
operate
(Auto-Cool-Dry-Fan
Only)
4)
Select the fan
speed
setting.
5)
The time you
selected
will
appear
in the LED
display
.
This is a “one-shot” timer.
It does not continue to cycle on and off.
It will turn the unit on (IF set by the user) ONE time. It will turn the
unit off (IF set by the user) ONE time. If you require the unit to turn
on/off again automatically, then you must set the timer again.
