Dugan Model E-2 User Guide
38
Selecting Units to Display
The Dugan Control Panel finds all available units connected to the network automat-
ically. Some facilities have multiple studios on the same network that operate inde-
pendently. In that case, you may want to restrict the units shown in the Top Pane to
those in your studio. To do this:
1.
Hover the mouse cursor over the names of the units that you want to display, and
note their IP addresses.
2.
Ctrl-click on the
+
sign at the right of the Top Pane.
The
+
sign turns red.
3.
Quit and relaunch the Dugan Control Panel.
It opens with
Auto Detect Disabled
in the Top Pane
4.
Click on the red
+
sign, and enter the IP address of the first unit you want to add.
5.
Repeat step 4 until your units all appear in the Top Pane.
Manually added units must also be removed manually. To remove manually added
units from the Top Pane, shift-click on the
+
sign. A dialog appears to confirm that
they have been removed.
To restore automatic detection, Ctrl-click on the
+
sign, which turns white.
Setting Controls
Controls can be adjusted five ways:
•
Enter a dB value in the numeric field.
•
Drag in the numeric field (not on iPad).
When a slider is present:
•
Drag the slider up or down.
•
Click in the slider track to raise or lower the value by 0.5 dB.
•
Ctrl-click anywhere on the slider to reset its value to 0 (touch and hold on iPad).
Summary of Contents for E-2
