Dalsa Pantera TF 11M4, User Manual

Page: 19 / 68

Pantera TF 11M and 6M User’s Manual Preliminary 19
DALSA 03-32-10096-03
2.2.3 Power Connector
H iro se 6 -p in C ircu lar M ale
5
4
6
2
3
1
M at in g P a r t: H IRO S E
H R 1 0 A -7 P -6 S
Pin Description Pin Description
1 +12V to +24V 4 GND
2 +12V to +24V 5 GND
3 +12V to +24V 6 GND
The camera requires a single voltage input (+12VDC to +24VDC). The camera meets all
performance specifications using standard switching power supplies, although well-
regulated linear supplies provide optimum performance.
When setting up the camera’s power supplies follow these guidelines:
• Protect the camera with a fast-blow fuse between power supply and camera.
• Do not use the shield on a multi-conductor cable for ground.
• Keep leads as short as possible to reduce voltage drop.
• Use high-quality
linear
supplies to minimize noise.
Note:
Performance specifications are not guaranteed if your power supply does not meet
these requirements
WARNING: It is extremely important that you apply the appropriate voltages to your camera.
Incorrect voltages will damage the camera. Protect the camera with a fast-blow fuse between
power supply and camera.
Visit the www.dalsa.com Web site for a list of companies that make power supplies that
meet the camera’s requirements. The companies listed should not be considered the only
choices.
2.2.4 Shutter Control Connector
Figure 12: Shutter Control Connector
Table 6: Shutter Control Connector Pinout Reference
Pin Description Pin Description
1 NC 4 NC
2 Direct Trigger In 5 GND
3 Shutter Control Out
1 2 3 4 5