Appendix A: GenICam Commands
•
63
Digital I / O Control Category
The Digital I / O Control features are used to
configure the camera’s GPIO pins.
Figure 24: CamExpert Digital I/O Control Category
Digital I/O Control Feature Descriptions
Display Name
Feature
Description
Standard
& View
Trigger Mode
TriggerMode
Determines the source of trigger to the camera,
internal or external
DFNC
Beginner
Internal
External
Trigger Source
TriggerSource
Determines the source of external trigger
DFNC
Beginner
CLHS In Source of trigger is from the frame grabber.
Rotary Encoder Source of trigger is from the two shaft encoder
inputs.
GPIO1 Source of trigger is from Line 1 of the GPIO
connector.
Trigger Input Line
ActivationEdge
TriggerActivation
Determines which edge of a input trigger will
activate on
. The two inputs are XOR’d together
when Shaft Encoder is selected to provide a single
signal.
DFNC
Beginner
RisingEdge The trigger is considered valid on the rising edge
of the line source signal (after any processing by
the line inverter module).
FallingEdge The trigger is considered valid on the falling edge
of the line source signal.
AnyEdge The trigger is considered valid on any edge.
Summary of Contents for ML-FM-16K07A
Page 17: ...Linea ML Multiline Monochrome HDR CMOS Cameras 17 Figure 8 Linea ML FM 16K Camera Mechanical ...
Page 18: ...18 Linea ML Multiline Monochrome HDR CMOS Cameras Figure 9 Linea ML HM 16K Camera Mechanical ...
Page 19: ...Linea ML Multiline Monochrome HDR CMOS Cameras 19 Figure 10 ML HM 08K camera mechanical ...
