Dalsa Everywhereyoulook Linea Lite GigE, User Manual

Page: 67 / 147

Linea Lite GigE Series Camera Operational Reference • 65
Output Line Pulse Delay outputLinePulseDelay Sets the delay (in µs) before the output line pulse signal.
Applicable for the OutputLineSource feature. Note, the
LineMode feature must be set to output.
Beginner
DFNC
Output Line Pulse Duration outputLinePulseDuration Sets the width (duration) of the output line pulse in
microseconds.
Beginner
DFNC
Output Line Value outputLineValue
Sets the output state of the selected Line if the
outputLineSoftwareLatchControl = OFF. OutputLineSource
must be SoftwareControlled. If the
outputLineSoftwareLatchControl = Latch , the state of the
pin will change with the
outputLineSoftwareCmd
command.
Beginner
DFNC
Active Active Sets the Output circuit to close
Inactive Inactive Sets the Output circuit to open
Line Status All LineStatusAll Returns the current status of all available line signals, at
time of polling, in a single bitfield. The order is Line1,
Line2, Line3, ... (RO)
Expert
Output Line Software
Command outputLineSoftwareCmd Writing a value of 1 in the bit field applies the Latch value
of the outputLineSoftwareLatchControl and/or executes
the PulseOnSoftwareCmd for any output line programmed
for software control. The feature outputLineSoftwareCmd
can take any binary value and each bit set to 1
corresponds to a Icommand for an Output.
Bit-0 is Line 3,
Bit-1 is Line 4,
Bit-2 is Line 5,
Bit-3 is Line 6
This is applicable to OutputLineSource = Pulse On: where
Software Cmd (for Pulse mode) or OutputLineSource =
SoftwareControlled and OutputLineSoftwareLatchControl =
Latch (for static states).
1.0Expert
DFNC
I/O Module Block Diagram
Line Selector =
Line 1 to 6
Physical
Line
Event Driven
Input
Inverter
Output
Inverter
Software Driven
Pulse
Generator
LineStatus
Trigger
Line
Activation
Trigger Signal
Timer
TimerEnd Event
CounterEnd Event
Software Trigger
Cmd
Line
Mode
Input
or
Output
Input
Output
Timer and Counter Module
Counter
Line
Debouncer
Event Driven
Trigger
Source
Trigger Module
Output
Line
Source
Signal Driven
Software Driven
Line
Detection
Level
Preliminary