dallmeier PANOMERA W8, Commissioning

Page: 34 / 48

W8
34 www.dallmeier.com
➡
First, wrap the delivered PTFE thread seal tape [Fig. 12 – B ]
around the entire thread length of your ceiling/wall mount bracket
[Fig. 12 –
A
] (at least three times) before you tighten the mount -
ing flange [Fig. 12 –
C
].
The tape has to be wrapped in the direction of the thread/arrows
(as shown in Fig. 12), i.e. clockwise when viewing the thread from
below (bottom view).
➡
Then, screw the mounting flange completely onto the ceiling/wall
mount bracket.
Do not rotate the mounting flange back (not even by a few degrees)
in order to ensure permanent tightness.
➡ Finally, secure the mounting flange with the two hexagon
socket head cap screws [Fig. 12 –
D
] before assembling the
Panomera® W8.
The two above-mentioned hexagon socket head cap screws are
already partially screwed in ex factory.
Instructions to Step
❽