Always use high quality cables like DALI Wave 5000.
9
English
Setting crossover frequency (when connecting via Line In - Left/Right)
With volume correctly adjusted, it is time for the equally important inte-
gration of the transition between the main speakers and S1.5. Simply turn
CROSSOVER up and down until you experience smooth, even bass with no
gaps. It may be necessary to re-adjust volume in connection with selection
of crossover frequency. If you are using the LFE input, this adjustment is
not active and crossover frequency should be adjusted in the set-up menu
of your surround processor.
Setting phase
Experiment with both settings – possibly with new adjustments of volume
and crossover frequency. It is a good idea to listen to the system for a few
days and then adjust again, if needed. The optimal setting for surround
may not be the same as for stereo. Make a note of which setting you prefer
for film and for music.
Setting Auto-function
In the AUTO position, the S1.5 will automatically go into Standby after
approximately 20 minutes without a signal. When the S1.5 detects a signal
again, it will automatically turn on. With the AUTO switch in the ON posi-
tion, the S1.5 will remain fully powered up as long as the main POWER
switch is in the ON position.
The POWER switch is the main On/Off control for the subwoofer. Always
turn off the system, if it is not to be used for an extended period of time.
Always turn the subwoofer completely off, whenever you connect or dis-
connect cables.
Overload
In the event of a major overload of the S1.5, the onboard protection circuit
will shut down the subwoofer. If this occurs, turn the system level all the
way down. To re-set the subwoofer, turn its main power switch off and
then back on.
Beware: The built-in protection circuit CANNOT provide unconditional
protection against damage as a result of overload.
Summary of Contents for S1.5
Page 1: ...www dali dk...
