Connect cables so that the loudspeaker is in correct phase.
The red (+) loudspeaker terminal must be connected to the
red (+) amplifier terminal. The black (-) loudspeaker terminal
must be connected to the black (-) amplifier terminal.
Remove insulation so that approx. ½” of bare wire is exposed.
Press the top of the terminal down and insert the bare wire
into the opening. When the wire is fully in place with no
loose strands exposed, release the terminal. The cable is now
connected.
Connection of Cables
Grille
NOTE: The grille is very tightly fitted to the loudspeaker to
prevent rattle noise. Therefore the grille can be difficult
to mount and dismount. To dismount the grille, carefully
press one end of the grille while pulling the grille from the
loudspeaker. When dismounted in one end, carefully pull the
other end of the grille. If you cannot grip the ends, you can
carefully use an awl or a small screwdriver. When mounting
the grille, be careful not to scratch the loudspeaker. Follow
the guide for dismounting the grille, but in reverse order.
On the inside of the grille there is a piece of non-woven. The
non-woven is on the grille to protect the drivers against dust
and dirt. Therefore the non-woven must remain on the grille.
