MINIMAX
Page 37
4
The sleeve (pos. 4) is removed from the piston rod (pos. 5).
5
The cap (pos. 3) is removed from the piston rod (pos. 5).
6
The gaskets are removed.
7
All parts are cleaned and checked for chips, burrs etc. Check for rust
around the scraper ring in the cap. If this is the case, remove it.
Mounting
1
New seals and a sleeve are mounted.
2
The thread on the cap (pos. 3) and the cylinder tube (pos. 1) are lubricat-
ed with oil or grease.
3
The cap (pos. 3) is mounted on the piston rod.
4
The sleeve (pos. 4) is mounted and the piston rod (pos. 2) is
secured
with Loctite
. Make sure the thread is completely clean and free of oil and
other impurities before using Loctite.
Do not fill the oil within 12 hours
of using Loctite.
5
Lubricate the outermost seal on the part of the sleeve in contact with the
cylinder tube as well as lubricating the innermost cylinder tube with oil,
and then push the piston into the centre position.
6
The cap is mounted on the cylinder tube and tightened.
7
To mount the cylinder, refer to “
Additional Equipment - Changing the cyl-
Summary of Contents for MINIMAX 950
Page 2: ......
Page 33: ...MINIMAX Page 33 8 Screw the cap on and tighten ...
Page 44: ...MINIMAX Page 44 Spare parts ...
