CULTITRAIL
Page 23
Rear levelling board
The levelling board for mounting on the rear can be set in different ways. Use the
spindles (A) to adjust pressure exerted on the ground. Move the board to the lowest
holes (A) to change attack angle. If moving the board down to these holes, the
spindles (A) must be shortened to avoid the board exerting too much pressure on
the ground.
Fig. 15
The purpose of the board is to level the soil surface after the harrow tines, and to
crush/press down clods. If the board is forced downwards too hard or works at an
angle which is too flat (if using holes (B)) clods could roll over the board and be left
on the soil surface. We therefore do not recommend applying too much pressure to
the board.
A
E
A
B
A
A
Summary of Contents for CULTITRAIL 500
Page 1: ...CULTITRAIL EN 500 600 cm Serial no 00100 XXXX ...
Page 2: ......