DALBO 77124, Manual, Page: 25 / 29

TRIMAX Plus
Page 25
4. Fit collar shoe (pos. 2) and screw on lock nut, secure with Loctite . Ensure
that thread is absolutely clean and free of oil or other impurities before
applying Loctite.
Do not fill with oil for 12 hours after use of Loctite.
5. Lubricate outer collar shoe gasket in contact with cylinder tube and in-
side of cylinder tube with oil, push ram into centre position.
6. Fit upper part onto cylinder tube and tighten.
7. Fit cylinder.
8. Connect hoses. Check hoses are not pinched and that connections are
tight.
Replacing hoses for hydraulic stone protector
Depressurise
the system by disconnecting from the tractor single-acting out-
let. Open ball cock and set tractor outlet to flow position. Replace the defec-
tive hose.
Replacing cylinder for hydraulic stone protector
Fig. 14
1.
Support the machine according to the instructions with the tines just
above the surface.
2. Depressurise the stone protector system.
3. Disconnect hoses.
4. Remove pins and split pins.
5. Fit new cylinder, replace pins and split pins.
6. Connect hoses.