MODEL NO.: BPT-2000B 5404L
－
Erp
INTRODUCTION
•
Before using your new heater, please carefully read through the
following instructions. KEEP THIS BOOKLET IN A SAFE PLACE SO
THAT YOU MAY CONSULT IT LATER.
•
After removing the packaging, make sure that the appliance is in
good condition.
•
The packaging materials may contain plastic, nails etc., which may
be hazardous and therefore should not be left within the reach of
children.
IMPORTANT SAFETY INFORMATION
Thank you for buying our product. Please read this instruction carefully
before operating the heater. Keep this operating instruction for future
reference.
•
1.The heater should be hung on the wall and make the wind outlet down
or be placed on flat appliance. You must not place it precipitantly or
tipsily.
•
2.Please do not use the heater in the place where full of combustible or
explosive gas. Don’t cover the wind outlet.
•
3.If the supply cord is damaged, it must be replaced by the manufacturer
or its service agent or a similarly qualified person in order to avoid a
hazard.
•
4.The heater must not be located immediately below an electrical
socket. The electrical socket must be equipped with earth wire, its
capacity should be 250V~10A or exceed 250V~10A. The socket and
the power plug should be in good connecting condition.
•
5.If nobody is in using or you are repairing the heater, please pull off the
plug.
•
6.Please don’t touch the heater by the wet hand or other conductor.
•
7.If motor is not working properly, please stop it immediately.
•
8. During using the heater, please do not open the door or window
continually otherwise it will influence the heating effect.
INSTRUCTIONS MANUAL
WALL MOUNTED HEATER
