DAL-BO Rollomaximum XL, Manual

Page: 36 / 43

Rollomaximum XL
Page 36
Removal/fitting wheel
Before removing wheel, fully extend the machine to the working position
with rings resting on ground. Wheels can then be raised off the ground.
Remove wheel nuts. Remove wheel. Replace wheel, hand-tighten wheel nuts.
Lower wheels to ground. Tighten wheel nuts to 510 Nm.
Ensure wheel nuts and wheel surfaces are clean to prevent nuts loosening.
Replacing rollers
Repairs must be performed with the machine connected to a tractor, resting on
a level surface, with the weight supported by the transport wheels.
This requires lifting gear, which can lift at least 1200 kg, as otherwise it will
not be able to overcome the spring preloading of 630 kg along with half of the
axle's weight.
1. Slacken bolts (A) without
entirely removing nuts.
2. This is attach to the topmost
cross-kill ring (B) and the
strap is tightened until the
bolts (A) are loose and can
be removed along with the
counterplate (C).
3. The axles is then lowered so
that the ring (B) rests on the
ground.
4. The same operation is then
performed for the other axle
end and axle, ring or bearing
are ready for repair.
Assembly
Assembly is in the reverse order to dismantling.
Note that a preloaded spring may spring back and cause personal inju-
ries. Therefore be very careful when working with preloaded springs.
A
B
C