DAL-BO Rollomaximum XL, Manual

Page: 17 / 43

Rollomaximum XL
Page 17
To reduce the height of the ma-
chine's centre of gravity and
lower the transport height to a
maximum of 4 metres, the ma-
chine can be lowered via the
wheel frame (A) (marked: yel-
low). The machine is lowered
until there is approx. 9 cm of
clearance under the centre cross-
kill axle (B)
To reduce the machine's
transport width to a maximum of
3 metres, the harrow section is
activated (A) (marked: white
valve bock no. 3), so that they
are pulled as far in to the ma-
chine's centre as possible. The
same is done with the machine's
crackerboard
(B) (marked:
green)
Always observe the correct sequence when retracting. i.e., the wheel
frame (marked: yellow) is first activated and the machine is lifted off
the ground. The tilt cylinder (marked: white valve block no. 4) is then
activated and the machine is tilted forward until the side frames and
the centre frame are in the upright position. The side frames can then
be retracted via the extend/retract cylinders (marked: red) and are set
down on the transport cradles via the tilt cylinder (marked: white valve
block no. 4).
This is very important for the machine's durability and safety that
the side arms remain in the transport cradles, when the machine is
transport in the retracted state.
A
B
9 cm
400 cm
A
B
300 cm