DAL-BO Rollomaximum XL, Manual

Page: 32 / 43

Rollomaximum XL
Page 32
3. Remove split pins from pins, remove pins
4. Remove cylinder
5. Fit new or repaired cylinder
After fitting, the harrow hoist is actuated until the cylinder shows a slight
travel. Reverse cylinder until it returns to start position. Move cylinder back-
wards and forwards several times.
If cylinder is not bled correctly as described above, there is a risk that part of
the machine
can suddenly move much quicker than normal, and before
the tractor driver can prevent it. This is because air (unlike oil) is com-
pressible. A section can therefore swing out very quickly if air bleeding is not
performed correctly. This represents a major risk of injury to personnel and of
damage to the machine.
Ensure no personnel are within the extension radius of the side sections.
Replacing gaskets on the harrow hoist cylinder
See the section "Replacing gaskets on tilt cylinder"
Replacing cylinder for the front centre cross-kill axle (black)
The machine is folded out to the
working position, the transport
wheels (A) are raised so that the
front centre cross-kill roller (B) is
just resting on the ground. The cyl-
inder is then depressurised (A).
1. Disconnect hoses from cylinder
2. Support cylinder
3. Remove split pins from pins, remove pins
4. Remove cylinder
5. Fit new or repaired cylinder
After fitting, the harrow hoist is actuated until the cylinder shows a slight
travel. Reverse cylinder until it returns to start position. Move cylinder back-
wards and forwards several times.
A
B
C