Maxiroll 2008
Page 35
Fitting axles with roller rings
1.
Position axles with roller rings and bearings corresponding to that
when Maxiroll is extended, resting on the ground.
2.
Extend roller and carefully lower over the axles.
3.
Fit bolts (A)
Ensure no personnel are within the machine's extension radius when activat-
ing hydraulics.
Do not activate hydraulics if there are personnel within machine extension
radius.
Replacing axles, bearings or roller rings
Fig. 33
1.
Slacken bearing screws (A) and
withdraw bearings
2.
Slacken stop ring bolts (B) and
withdraw stop rings.
3.
Withdraw roller rings from axle
4.
Reverse order to reassemble
5.
Apply Loctite to bearing screws
Crosskill ring
Fig. 104
Note axle direction of rotation.
1.
After the outer stop ring (
Fig. B) there is a smaller
ring.
3.
Fit bushing (A)
4.
Fit large ring (B)
5.
Finish off with a small ring,
and then fit a stop ring.
Tromle midt
B
A
B
A
Summary of Contents for Maxiroll 1030 2008
Page 1: ...Maxiroll 2008 EN 1030 1230 Serial no 100 XXX ...
Page 2: ......
Page 38: ...Maxiroll 2008 Page 38 Hydraulic diagram Fig 35 ...
Page 41: ...Maxiroll 2008 Page 41 Fig 38 ...
