Daktronics WR-2101, Display Manual, Page: 9 / 38

Mechanical & Electrical Installation
5
Signal
1. Route the signal cable from the display to the control location.
2. Plug the signal cable into the J31 SIGNAL IN jack on the side of the display.
3. Plug the other end of the signal cable into the J1 or J2 on the All Sport 1600 ( J1 , J2 , or
J3 jack on the back of the All Sport 5000).
Note: Refer to the electrical and signal specification drawings in Appendix A for
additional information and typical system setup examples.
Special note to users of All Sport 4000 and Pro Sport 6000 Control Consoles:
Current standard models in the Daktronics Matside Jr. wrestling display lines are factory
configured to operate only with the All Sport 1600 and 5000 series control consoles. If
one of these standard scoreboards is sent as a replacement, the address plug must be
removed from the scoreboard to properly receive signal from older controllers. Simply
unplug the P19 address plug from connector J19 on the LED driver. Refer to LED Drivers
(p.7) . If any problems occur with this procedure, contact the Daktronics.