Daktronics TI-2022, Display Manual

Page: 8 / 32

Mechanical Installation
4
2 Mechanical Installation
This section describes the mounting details of the TI-2022. Use this section when mounting
a display to a wall or on the tripod kit. Other mounting methods can be used, but
Daktronics engineers do not recommend those not documented here. Daktronics is not
responsible for mounting the display.
Note: Daktronics assumes no liability for any installation derived from the information
provided in this manual or installations designed and installed by others.
Wall Mounting
The TI-2022 mounts to a wall using an optional mounting bracket (Daktronics part #
0M-173125). This bracket then attaches to two wall anchors. A qualified engineer must
specify the anchor type according to national and local building codes.
Note: Do not attempt to permanently suspend the TI-2022 by its carrying handle.
Also, do not permanently mount outdoor displays or leave in wet weather.
Before beginning installation, place the bracket against the mounting surface, level it,
and then mark the surface through the anchor holes on the bracket with a marker or
heavy pencil. Drill holes in the wall and install anchors at the marked locations. Minimum
steel anchor size is 3/16" diameter (4.7 mm).
Note: Due to the variety of wall materials used in sports facilities, Daktronics cannot
anticipate every user’s installation needs or provide mounting hardware suitable
for every installation. Choose a method of installation that will safely support the
display’s weight.
Refer to Figure 4 for display mounting instructions:
Wall Mounting Bracket
(0M-173125)
1.
Mount the bracket to
the wall.
2. Loosen 4 screws on
sides of display, slip
them into slots on
bracket, and re-tighten.
Figure 4: Wall Mounting Kit Installation