Sportsound SSR-200 Gen II Quick Start Guide
DD3159573
Rev 02
01 April 2019
201 Daktronics Drive Brookings, SD 57006
www.daktronics.com/support
800.325.8766
Page 3 of 5
The unit displays the following information:
a)
Transmitter Battery Life
b)
TV Channel
c)
Frequency
d)
Group Number
e)
Channel Number
f)
RF Signal Strength
g)
Transmitted Audio Level
h)
Gain Level
Single Receiver
1.
Ensure all transmitters are powered off. Press the power button to
turn on the receiver if it is not already on.
2.
Press
menu
until “scan” displays on the LCD.
3.
Press
enter
to start frequency scan. When scan is complete,
Group and Channel will display on the LCD.
Network Receivers
1.
Ensure all transmitters are powered off. Turn on all receivers and
wait one minute to allow time to connect to the network.
2.
Press
menu
on one receiver until group number flashes.
3.
Use the arrow buttons to select a group to scan.
4.
Press
enter
, wait for channel, and then press enter again.
5.
Press
menu
until “network scan” displays on the LCD.
6.
Press
enter
twice to deploy channels to other receivers.
Note:
Perform a scan on all of the wireless units just minutes
before the game! If a scan is performed too far ahead
of time, frequencies set up by the media later on may
interfere with previously configured settings.
1.
Open the battery cover. Insert new or fully-charged AA batteries
prior to each use, and always have spares on hand.
2.
Power on the transmitter device.
3.
Hold the transmitter device up close to one receiver in the rack,
ensuring the infrared (IR) windows are aligned.
4.
Press
sync
on the receiver; “good” will display if sync succeeded.
5.
Repeat steps 1–4 to pair another transmitter device with an
additional receiver (if present).
Note:
Plug the referee mute switch into the jack on top of the
bodypack unit and plug headphones/lapel mic into the
referee mute switch.
Verify Reception:
With a transmitter and the receiver both turned
on and having matching GROUP and CHANNEL numbers, the RF
meter on the receiver should be indicating signal. Speak into the
microphone and the Audio meter should indicate signal presence.
Wireless Receiver System Operation
Wireless Microphone & Bodypack Operation
Power
IR Window
a
e
b
c
d
g
f
h
Power
ON/OFF
Power
ON/OFF
IR Window
