Sportsound SSR-200 Gen II Quick Start Guide
DD3159573
Rev 02
01 April 2019
201 Daktronics Drive Brookings, SD 57006
www.daktronics.com/support
800.325.8766
Page 5 of 5
Optional Hearing Assist System Operation
Transmitter
1.
Press
POWER
to turn on the transmitter if it is not already on.
2.
Use the
CHANNEL SELECT
buttons to select a channel.
3.
Plug the Ear Phone/Neck Loop lanyard into the 2 jacks on top of
the receiver, and then connect the Ear Speaker into the jack on
the lanyard.
4.
Press and hold the power button for 1 second to turn on the
receiver. (To turn off the receiver, press and hold the power
button for 3 seconds.)
5.
Verify the channel number matches on both the receiver and
the transmitter. To change the channel, press and hold the up
and down buttons at the same time for 5 seconds, and then use
the up and down buttons to select the channel. Press the power
button to save.
Note:
Receivers use rechargeable Lithium-ion batteries. Always
charge receivers at least 2.5 hours before the event.
6.
Repeat
Steps 3–5
for any additional receivers.
The universal antenna kit may be located up to 10' (3 m) away from
the rack, mounted to the ceiling or a wall. Ensure there is enough
room to fully extend the antennas and that the coaxial cable is
plugged into the
WTX2
jack on the top of the rack.
Receiver
1
2
3
4
5
