Daktronics MS-2113, Manual

Page: 8 / 50

Mechanical Installation
4
3 Mechanical Installation
Mechanical installation involves assembly of the cart. The
scoreboard itself requires no assembly or permanent installation.
Some assembly is required, however, for certain scoreboard
options. Scan the QR code at right to view a quick cart
assembly video.
Cart Assembly
Reference Drawings:
Mechanical Specifications, MS-2113 ............................................................. DWG-3270213
Cart Assembly, Portable Display ..................................................................... DWG-3274045
The display cart ( Figure 4 ) comes standard with four wheels. Cart assembly requires the
following pieces of hardware:
• T-stands @ 2
• Axle tubes @ 4
• 10" wheels @ 4
• 5/8"-11 x 3" bolts @ 4
• 5/8"-11 nuts @ 4
• 5/16" diameter pins with clips @ 6
A 15/16" wrench is needed to attach the
wheels.
Refer to
DWG-3274045 in Appendix A and
the following instructions to assemble the
cart:
1� Insert the axle tubes into the T-stands,
and secure them using pins with
retaining clips.
2� Mount the scoreboard by inserting the two T-stands into the larger tube attachments
on the sides of the scoreboard, and secure the stands using pins with retaining clips.
(The tubes mounted on either side of the scoreboard are permanent attachments;
do not remove them during cart disassembly.)
3� Slide a 5/8"-11 x 3" bolt through a wheel, and then screw a 5/8"-11 nut onto the bolt.
Attach the bolt/wheel/nut assembly to an axle tube. Tighten the bolt with a 15/16"
wrench. Repeat this process for the other wheels. The wheels should be snug in place
but still able to freely rotate.
Adjusting the Cart
Caution! Do not raise the display in high winds or transport the display in the raised
position. These actions increase the likelihood of tipping over and causing injury or
damage to the display.
DWG-3270213 in Appendix A shows the two axle positions that may be used with
the cart. The extended axle position provides maximum stability and should be used
whenever the display is raised. Use the narrow axle position (and lowest height) to move
the display through doorways and for storage. The drawing also illustrates front profiles of
the display in transport position and at maximum viewing height.
youtu.be/G4zcF3RbavQ
T-Stand
Locking Pin
Wheel w/ Bolt
Axle Tube
Mounting Tube
Figure 4: MS-2113 Cart Assembly