Electrical Operation
7
Whether or not the display is operational, its batteries will continue to discharge any
time the switch is in the
ON
position.
Leaving the switch ON when the display is not in use
could completely discharge and damage the batteries.
Refer to
DWG-3275249
in
Appendix A
for component locations and illustrations of internal
and external wiring.
DWG-4107359
provides a detailed wiring schematic for advanced
troubleshooting.
Keep the display plugged in to a 120 VAC power source during storage. Battery life
is enhanced by keeping the batteries fully charged. Typically, batteries will be fully
charged in about 12 hours and will give about 14 hours performance on a full charge.
Signal
Reference Drawing:
System Riser Diagrams- MS-2113 .....................................................................
DWG-3274967
The MS-2113 can receive control signal four different ways as described below. Refer also
to
DWG-3274967
in
Appendix A
for diagrams of each of these control setups.
•
Setup 1:
A wireless RC-100/200 handheld controller communicates with a radio base
station installed inside the scoreboard.
•
Setup 2:
A 4-pin cable connects the scoreboard directly to the All Sport. The cable
transmits signal to the scoreboard and power to the controller.
•
Setup 3:
A control console equipped with radio transmitter and its own battery pack
or a separate power cord communicates with a radio receiver installed inside the
scoreboard.
•
Setup 4:
CUSTOMER-SUPPLIED mobile device or tablet with DAK Score app installed
communicates via
Bluetooth
®
wireless technology to the MX-1 Interface Box, which
connects to the scoreboard with a 4-pin cable.
Connecting Signal Cable
If the display was ordered with a wired control console, simply plug the 4-pin signal cable
into the jack labeled
CONTROL CONSOLE CONNECT
(
). Attach the mating plug to
the modified power cord from the All Sport controller. Extension cables are also available
from Daktronics if more cable is needed than the provided 100' (30.5 m).
Base Station & Radio Receiver Installation
Reference Drawing:
Radio Receiver Installation- MS-2113 .............................................................
DWG-3276286
The RC-100/200 base station and All Sport radio receiver when ordered as original
equipment may already be installed. In this case, the only installation required is
attachment of the radio antenna, which may have been shipped separately to prevent
damage. If the base station or radio receiver is not already installed, refer to
DWG-
3276286
. Refer also to the
MS-2113 Radio Installation Quick Guide (DD4661729)
, shipped
with the scoreboard and available online at
.
Summary of Contents for MS-2113
Page 26: ...Daktronics Exchange and Repair Return Programs 22 ...
Page 28: ...This page intentionally left blank ...
Page 29: ......
