Daktronics H-2024-9, Installation And Maintenance Manual

Page: 14 / 55

2-8 Mechanical
and Electrical Installation
2.5 Signal
Reference Drawings:
Signal Connection, Installation............................................................... Drawing A-28124
Rear View, A/S 5010 Connectors ........................................................ Drawing A-102142
Electrical Specs, H-2024...................................................................... Drawing A-126742
Electrical Specs, H-2024 w/TNMC ....................................................... Drawing A-126677
Electrical Specs, H-2026...................................................................... Drawing A-126743
Electrical Specs, H-2026 w/TNMC ....................................................... Drawing A-126681
Electrical Specs, H-2031...................................................................... Drawing A-126744
Electrical Specs, H-2031 w/TNMC ....................................................... Drawing A-126682
Signal installation requires routing control cables from the scoreboard control console to a signal
junction box. Refer to the signal connection and electrical specification drawings located in the
Appendix .
1. Use a paired, 24 AWG (minimum) shielded cable and connect the cable to the junction box
at the control end.
2. Route the cable from the junction box to a signal junction box located near the display.
3. Route the signal wires from the junction box near the display to the first section.
4. Insert the plug into the jack labeled "Signal In" located on the right side of the scoreboard.
5. Begin with one signal cord and plug it into the jack labeled "Signal Out."
6. Insert the signal cord into the "Signal In" jack on the display next to it.
7. Continue to connect each section to the next one until all the sections are connected.
Displays without team name message centers have three signal jacks on the cabinet back panels.
Displays with team name message centers have four signal jacks. Refer to
Drawing A-28124 for
more information.
h
Special Note to Users of Daktronics All Sport 4000 Series and Daktronics Pro Sport 6000
Control Consoles:
Current standard models in the Daktronics scoring and timing display lines are configured at the
manufacturing plant to operate with the All Sport Series 5000 Control Console. If you receive
one of these standard scoreboards, you may need to remove the address plug before your
scoreboard can properly receive signal. Simply unplug the address plug, P19, from connector J19
on the LED driver. (The plug is typically looped into the connector cable harness.) If you have
problems in this regard, contact the Daktronics Help Desk or your project manager.