Daktronics GALAXY GT6 Series, Installation And Operation Manual

Page: 35 / 42

Replacing Parts
31
2� Disconnect the cables from the controller.
3� Loosen the screw securing the controller enclosure and bracket.
4� Carefully lift the enclosure up and out of the display.
5� Insert the new enclosure and tighten the screw.
6� Reattach the cables to the controller using the labels and reference drawings as a
guide.
PLR Replacement
The PLR is located behind the third module up from the bottom in the first column of
modules. Refer to Figure 21 . If the display has two PLRs, they are located in behind the
third and fifth columns. PLRs can be found in both Primary and Mirror display faces as well
as all sections of a sectional display.
1� Remove the module in front of the PLR.
Note: Do not allow the modules to hang by their cables.
2� Disconnect the two SATA cables, fiber cables, and power cable to the PLR.
3� Loosen the screw at the top of the PLR mounting plate.
4� Lift the mounting plate up and out of the display.
5� Insert the new PLR with mounting plate and tighten the screw.
6� Insert the two SATA cables, fiber cables, and power cable in the appropriate
locations.