Section 1:
Introduction
This manual explains the installation, maintenance, and troubleshooting of Daktronics
Galaxy
®
AF-3300 series LED displays. For questions regarding the safety, installation,
operation, or service of this system, please refer to the telephone numbers listed on the cover
page of this manual.
The manual is divided into six sections: Introduction, Mechanical Installation, Electrical
Installation, Maintenance and Troubleshooting, Appendix A and Appendix B.
•
Introduction
covers the basic information needed to make the most of the rest of
this manual – take time to read the entire introduction as it defines terms and
explains concepts used throughout the manual
•
Mechanical Installation
provides general guidance on display mounting
•
Electrical Installation
gives general guidance on terminating power and signal
cables at the display
•
Maintenance and Troubleshooting
addresses such things as removing basic display
components, troubleshooting the display, performing general maintenance, and
exchanging display components
•
Appendix A
lists the drawings referenced within this manual
•
Appendix B
includes information on the Optional Temperature Sensor
Daktronics identifies manuals by an ED number located on the cover page of each manual.
For example, this manual would be referred to as
ED-15507
.
Listed below are a number of drawing types commonly used by Daktronics, along with the
information that each is likely to provide. This manual might not contain all of these
drawings:
•
Shop Drawings:
Fan locations, mounting information, power and signal entrance
points, and access method (front and rear)
•
Schematics:
Power and signal wiring for various components
•
Component Placement Diagrams:
Locations of critical internal display
components, such as power supply assemblies, controller boards, thermostats, and
light detectors
illustrates the Daktronics drawing label. The drawing number is located in the
lower-right corner of the drawing. Listing the last set of digits and the letter preceding them
identifies drawings in the manual. In the example below, the drawing would be referred to as
Drawing B-222544
. Reference drawings are inserted in
Appendix A
.
Figure 1: Drawing Label
Introduction
1-1
