Daktronics FLR3-100, Installation Quick Manual

Page: 3 / 4

FLR3-100 Installation Quick Guide
13 June 2017
DD2291475
Rev 06 201 Daktronics Drive Brookings, SD 57006
www.daktronics.com/support
800.325.8766
Page 3 of 4
Number Configuration
This section steps you through configuring the numbers six
and nine and the fraction display preferences.
1. Make sure display is turned on.
2. Press and hold the -3 and +3 buttons on the key fob
until all displays show the numbers 6 and 9. The number
scheme will be either 3.69 9/10 or 4.69 9/10. Refer to
Figure 5 .
3. Press the Plus (+) or Minus (-) keys to scroll through the
different configuration options.
4. When the desired configuration is shown on the
displays, press and hold the -3 and +3 buttons to exit
configuration mode.
Entering Test Mode
Entering test mode causes the displays to cycle through
various pieces of information that can be useful when
working with Daktronics Technical Support.
1. Press and hold the -4 and +4 buttons of the key fob until
the displays begin cycling through test mode.
2. Exit test mode by pressing and holding the -4 and +4 buttons until the displays return to showing
prices; approximately five seconds.
Controlling Five or More Fuel Grades or Multiple Pylons
Use the following steps when controlling more than four fuel grades in the same pylon or when more
than one pylon exists on the same site.
Important Terms
• Host Display - Display that has the receiver card connected to it.
• Fuelight System - Host display and all other displays that are connected to the host with a line to line
cable.
No Tails and 9
No Tails and 9/10
Tails and 9
Tails and 9/10
Figure 5: Digit Configurations
No Tails and 9
Tails and 9
Figure 6: International Digit Configuration
Note: For Domestic displays with a 9/10s digit, the
number 3 needs to show in the first column for
the desired format. For International displays,
make sure the number 4 shows in the first
column for the desired format.
Note: International displays offer two configuration
options - tails and 9 and no tails and 9, as
shown in Figure 6 .
Note: The same instructions apply to installation in a sign shop or on site.
Note: Two or more FLR3-100 key fobs are required.
Note: Each keyfob is limited to controlling a maximum of four grades and only displays a single pylon.