POS Interface
41
Section 9:
POS Interface Installation and
Operation
A Point of Sale (POS) interface option is available with DataMaster LED Petroleum Price Displays.
Displays with this option automatically update when product prices are changed in the POS.
Displays with the POS interface option will be supplied with a POS Interface Kit (see table below for
part numbers).
9.1 System Installation
1.
Ensure that the P.O.S. system has a price sign output port. Refer to the P.O.S. manuals to
ning:
tion (0A-1196-0133)
ber)
99) for direct wired installations or Radio Interface
e (W-1267) to the junction box as shown on the riser diagram.
Coil any excess cable and cable-tie it out of the way.
enable and/or configure the port.
2.
Locate the following parts:
a)
POS Interface Kit contai
i)
DataMaster 100 w/POS op
ii)
Wall mounting bracket for DM-100 (0M-200082)
iii)
POS Interface Cable (refer to table 7-1 for part num
iv)
POS riser diagram (refer to table 7-1)
b)
c
10
′
cable, DB9 to DB9 (W-1267)
)
Indoor junction box (0A-1196-00
junction box (0A-1279-0161) for wireless installations.
Wallpack transformer (T-1118).
d)
Mount the wall bracket (0M-200082)
3.
to provide convenient storage for the DM-100
controller. When using the wall-mount bracket for the DM-100, ensure that clearance is
sufficient above the bracket to allow the DM-100 to be removed from the bracket with
both cables attached. Also ensure that the POS interface cable will reach from the DM-
100 location to the price sign output of the POS. Fasten the wall-mount bracket if desired.
The DM-100 can be permanently attached to the wall mounting bracket by removing the
two screws in the bottom edge of the DM-100, sliding the DM-100 into the wall mount
bracket, and reinstalling the screws through the slots in the bottom bracket flange.
Mount the junction box (refer to step 1.c. above). Ensure that the DB9 to DB9 cable (
4.
W-
1267) will reach from the DM-100 to the junction box.
Complete junction box to sign or junction box to radio
5.
wiring as shown on the riser
diagram (drawing 200195).
Attach the P.O.S interface ca
6.
ble to the P.O.S price sign port. Coil any excess cable and
cable-tie it out of the way.
7.
Attach the DB9 to DB9 cabl
P.O.S. Interface
Type
Interface Kit
Required
Interface Cable
Riser Diagram
Gilbarco G-Site
0A-1279-0400
0A-1279-0402
200195
Gilbarco PAM 1000
0A-1279-0452
0A-1279-0229
224628
Allied 0A-1279-0443
0A-1279-0144
215840
Verifone Sapphire
0A-1279-0146
0A-1279-0145
200195
