Daktronics 65 Series, Installation Manual

Page: 16 / 29

Multi-Direction Light Sensor Relocation
12
5 Multi-Direction Light Sensor Relocation
The Multi-Direction Light Sensor (MDLS) ships attached to the display borders in a location
provided by the Project Manager. If needed, use the following steps to move the MDLS
to a location that receives the same light as the display face.
Multi-Direction Light Sensor Relocation
1� From the back of the display, disconnect the
cable that connects the MDLS to the display.
2� Carefully cut the zip ties that secure the cables
to the anchor locations on the display back.
3� Loosen the attachment bolts that hold the
MDLS assembly to the MDLS mounting arm.
Refer to Figure 20 and Figure 21 .
4� Lift the MDLS assembly off of the MDLS
mounting arm.
5� Remove the two tek screws that secure the
MDLS mounting arm to the border. Refer to
Figure 20 and Figure 21 .
6� Remove the MDLS mounting arm from the
border.
7� Rotate the MDLS mounting arm vertically
180 degrees until the MDLS assembly can be
reattached to the MDLS mounting arm.
8� Place the MDLS assembly on the MDLS
mounting arm.
9� Use the attachment bolts and nuts to secure
the MDLS assembly to the mounting arm.
10� Use tek screws to secure the MDLS mounting
arm and MDLS assembly to the border at the
new location.
Note: Ensure the front label on the MDLS assembly is on top, the arrows are facing
away from the display face, and all three light sensor windows are free from
obstruction. If you have any questions about the MDLS mounting, contact the
Project Manager or Daktronics help desk.
11� Connect the MDLS cable to the Light Sensor connection in the Internet and webcam
connections location (third bay from the right).
Note: If after moving the MDLS the cable is not long enough, request an extension
cable from the project manager. Connect the extension cable to the MDLS
cable and to the back of the display.
12� Secure any excess cable to the provided anchor points on the back of the display.
Attachment
Bolt
MDLS
Assembly
Tek
Screw
MDLS
Mounting Arm
Border
Figure 20: MDLS on Right Side of Display
(From Front)
MDLS
Mounting
Arm
Attachment
Bolt
MDLS
Assembly
Tek
Screw
Border
Figure 21: MDLS on Left Side of Display
(From Front)