27
Webcam Access and Troubleshooting
Section 9: Webcam Access and Troubleshooting
The information is this section describes how to retract the webcam to the display face for service and
provides some basic troubleshooting steps. Work with the help desk to verify the camera is aligned and
in focus after servicing or cleaning the webcam.
9.1 Retracting the Webcam to the Display Face
1. Remove the three short bolts from the elbow assembly. Refer to
Figure 23.
Note: Do not remove the long bolts in the collar.
2. Use the handle to carefully pivot the webcam arm to the front of
the catwalk.
Note: Verify that any webcam cables are not getting pinched or
pulled when pivoting the webcam arm.
3. Return the webcam arm to the original position when servicing
the webcam.
4. Replace and tighten the three short bolts.
5. Work with Daktronics help desk to verify the webcam is focused
and functioning properly.
9.2 Webcam Troubleshooting
This section provides some basic power troubleshooting steps
to perform if the webcam is not functioning properly. Refer to
Figure 24 while reading the table below.
Handle
Short
Bolt
Figure 23:
Webcam Arm
Bolts
Red LED
Green LED
Figure 24:
Webcam LED Status
Indicators
