9. Attach wire connector to power-supply circuit board.
Make sure the Connector is lined up correctly – it will
only go in one way. Push it all the way in – make
sure both side-tabs are “clicked” in place. Gently pull
on it to verify it is locked, then gently push it back
down to ensure a good connection.
10. Attach S/N Cover using 2 #6 Self-Tapping Screws.
11.Make sure all fasteners are tight. (Careful not to over
tighten the #6 nuts!)
12.Congratulations! Your grill is assembled. It is almost ready for use.
13. Plug the grill into a properly grounded GFCI-protected outlet and turn it on. Make
sure everything is working correctly. After the grill starts heating, place your hand
near the elements (don't touch!) – you should feel heat radiating from each.
14. If something is not working correctly, use caution and unplug it immediately. Call
us right away at (605) 847-4713. If there is no answer, you can also try calling
Adam's cell phone at (605) 695-0069.
15. Open the lid and insert the drip pan, smoker tray,
heat-shields and cooking grates. The bottom grate
and back heat shield are shown in the picture at right.
If you look closely, you can also make out the smoker
tray nestled behind the heat-shield.
Note: The drip
pan goes in the very bottom of the grill, beneath the
heating elements. The smoker tray attaches between
(605) 847-4713
(605) 847-4713
44136 200th St.
44136 200th St.
5/6
www.dakotagrills.com
www.dakotagrills.com
Lake Preston, SD 57249
Lake Preston, SD 57249
