13.
Next, while holding onto the
R Handle
, start the
two hex-head bolts in front (repeat
Step 10
). Tip:
a second person may be helpful for aligning and
holding the handle while you start the two bolts.
Tighten with 7/16” wrench.
14.
Attach #6
nuts on back. (Same as S
tep 10
). Finger
tighten.
15.Attach wire connector to power-supply circuit board.
Make sure the Connector is lined up correctly – it will
only go in one way. Push it all the way in – make
sure both side-tabs are “clicked” in place. Gently pull
on it to verify it is locked, then gently push it back
down to ensure a good connection.
16. Attach S/N Cover using 2 #6 Self-Tapping Screws.
17.Make sure all fasteners are tight. (Careful not to over tighten the #6 nuts!)
(605) 847-4713
(605) 847-4713
44136 200th St.
44136 200th St.
7/8
www.dakotagrills.com
www.dakotagrills.com
Lake Preston, SD 57249
Lake Preston, SD 57249