3. Now it is time to attach the legs. First, attach the bottom of the two
Front Legs
, as
shown below, with a self-tapping screw. You may use the leg as a lever to hold it in
place while starting the screw. If this is a struggle, you may use a 1/4” hex-head bolt
(use a 7/16” wrench) with the included washer to hold the leg in place while attaching
the screw; remove the hex-head bolt when done. The
Front-Left Leg
is shown.
4. Second, attach the middles of the two
Back Legs
, as shown below, with three self-
tapping screws apiece. Do not put screws in the bottom two holes at this point. Again,
you may need to “lever” each leg as you attach the screws.
Note: Once the first screw
is in, you may tighten it to hold the leg in place.
The
Back-Left Leg
is shown.
5. Third, attach the
triangle pieces
of all four legs, as
shown at right, each with two self-tapping screws.
Make sure all screws are snug, then flip the
Grill
Body
upright so it stands on its legs. The
Front-Left
Leg
is shown.
(605) 847-4713
(605) 847-4713
44136 200th St.
44136 200th St.
4/8
www.dakotagrills.com
www.dakotagrills.com
Lake Preston, SD 57249
Lake Preston, SD 57249
(Left)
(Front)
(Front) (Left)
(Back)
(Left)
(Right
)
(Back)
(Left)
(Left)
(Front
)
