MAN# 650052
1
ODYR-24-1 and SLX-24-1
Air Bag Display and Control System
Introduction
This control system connects to a display module and pressure senders to allow monitoring and
control of all four corners and optional monitoring of the tank pressure. Each bag can be
manually raised or lowered as well as control of the front two together, rear two together, or all
four together. The bag senders can be either 150 psi units or 400 psi units for high pressure
systems. The tank sender is always the 400 psi unit.
This control system can also be connected to a remote transmitter system to allow individual
remote control of the air bag system. The functions include individual corner up/down, all
up/down, front up/down, and rear up/down.
IMPORTANT: Make sure to always disconnect the negative cable from the battery if you are
going to be working on or under the vehicle. Failure to do so can result in serious injury if the
system is accidentally activated.
Wiring
Main connector
RED
constant 12V power
BLACK
ground
YELLOW
12V accessory power
BLUE
night dimming (connect to tail light or head light circuit)
WHITE/GREEN
right rear down solenoid (not used for FRONT/REAR setup)
GREEN
right rear up solenoid (not used for FRONT/REAR setup)
WHITE/PURPLE
left rear down solenoid
PURPLE
left rear up solenoid
WHTE/ORANGE
right front down solenoid (not used for FRONT/REAR setup)
ORANGE
right front up solenoid (not used for FRONT/REAR setup)
WHITE/BROWN
left front down solenoid
BROWN
left front up solenoid
Sender connector
GREEN
right rear pressure sender (not used for FRONT/REAR setup)
PURPLE
left rear pressure sender (rear sender for FRONT/REAR setup)
ORANGE
right front pressure sender (not used for FRONT/REAR setup)
BROWN
left front pressure sender (front sender for FRONT/REAR setup)
GRAY
tank pressure sender
BLACK
ground to senders
Display connector
Mates to display
Remote receiver connector
Mates to ARR-2000 module harness connector
