MAN# 650052
9
TRANSMITTER PROGRAMMING
All of the transmitters to be programmed into the system should be available. This sequence will erase any
previously programmed transmitters. If a transmitter is lost or stolen, go through the programming sequence with
the remaining transmitters and the lost one will be erased.
1. Push and hold in the joystick while you turn the key on. The display should light up and show “SETUP”
“MODE”.
2. Release the switch. Push the joystick up or down until “REM” “SETUP” is displayed.
Push in and release the joystick. The display should show “REM” “MODE”.
3. Push the joystick up or down until “REM” “PRGM” is displayed. Push in and release the joystick. The display
should show “PRS 3” “TWICE”.
4. Press button three twice on each transmitter. (If you wait to long it will exit the setup routine.)
5. Turn the key off when done.
BATTERY REPLACEMENT
Should the transmitter function become weak or erratic, the battery in the key chain transmitter may be weak.
An indication of a weak battery is that the red indicator may have a dim glow to it when either button is pressed. If
this occurs, first check the system by using the second transmitter provided. If the second transmitter functions
properly, replace the battery in the defective transmitter by the following method:
A. Use a small, flat screw driver or knife to pry the case apart next to the chain.
B. Carefully separate the two case halves.
C. Remove the battery noting the (+) and (-) position.
D. Replace the battery with a new 12 volt type GP23A battery which is available at most electronic stores
(Radio Shack, etc.).
E. Carefully replace the top cover snap it into place.
F. Check transmitter function.
TROUBLE SHOOTING GUIDE
IMPORTANT: Make sure to always disconnect the negative cable from the battery if you are
going to be working on or under the vehicle. Failure to do so can result in serious injury if the
system is accidentally activated.
Symptom
Possible Problem
Solution
----------------------------------------------------------------------------------------------------------------------------------------------------
System will not operate any of the
Ignition key is on.
Turn off ignition.
solenoids.
Accessory input is powered
Check connection to Acc. wire.
Remote module is not plugged in.
Connect connections.
Air solenoids ‘jump’
Weak or poor 12 volt connection.
Check 12 volt connection.
or ‘chatter’.
Move to new terminal point.
Bags change direction in
Over loaded 12 volt power circuit.
Place receiver and windows on
mid-travel.
separate circuits.
Check for loose connections.
Increase wire size on power.
Weak car battery.
Recharge or replace car battery.
Transmitter signal is being disrupted.
Move antenna away from power
wires.
Transmitter has very short range
Transmitter battery is weak.
See Battery Replacement.
on all functions.
Antenna needs repositioning
Move antenna out away from
any high current wires.
When the system is ready to receive a transmitter signal, the red light should be flashing slowly. If it is not, begin
checking the power and ground connections.
If none of these solutions solve the problem, or the problem occurring is not listed here, please call the Dakota
Digital technical assistance line at (605) 332-6513 for further assistance or email to
[email protected].
