MAN #650776
13
MBMS Display which MBMs are connected and adjust warnings
If a pressure or boost sensor is not connected or failed, the
O
.
If no MBM is attached but the display shows a blank value, click through the displays to remove it.
, and release.
The screen will display what MBM modules are attached and more than one input if it exists.
NONE
ent.
Press and release the switch to move through the MBMs attached.
Press and hold the switch
on the MBM setting to modify.
o
See the separate MBM manual for additional details.
Exit Setup.
VOLT Low voltage warning setup
When >
displayed, and release.
The low voltage warning points will range from 9.0 to 12.1 volts.
Press and release the switch to change the low voltage warning point.
Press
, and release.
Exit setup.
GEAR Gear indicator setup
Nothing will show until programming is done.
The gear programming cannot take place until the speed is calibrated.
The gauge can learn the gear ratios based on speed and RPM, no additional sensors are needed.
It will work with various transmissions up to seven speed models.
To program the gear positions, you will need a stretch of road to gradually reach highway speeds with no interruptions.
Each gear will need the speed to be held steady, until instructed to speed up and shift up.
>> Gear programming requires holding the function switch, THEN starting the engine <<
Once the engine is running, release the switch.
Press and release the sw
Press and hold the swit
.
The display will sh
OFF
o
OFF
rn the indicator off.
o
starts the leaning process of speed and RPMs to calculate your gear reading.
To reset the gear to n
OFF .
o
ed, then release the switch.
o
Press and hold again to return to Gear menu.
To start learning gears
>
o
if the engine RPM is below 1500.
o
The message could also say
the vehicle speed is below 5 MPH.
Begin rid
Ride at a steady speed and steady RPM until the message
.
It should only take about 20 seconds if the speed and RPMs are steady.
o
Optional: If the message
, you can manually override and jump to the next gear by
pressing and releasing the switch to store the gear position quicker.
Upshift to 2nd gear and ride at a steady speed. The display
Ride
o
Optional: If the
you can manually override and jump to the next gear by
pressing and releasing the switch to store the gear position quicker.
Repeat this through each gear.
When you are done, come to a complete stop.
o
You may also press and hold the switch, while riding, until the display shows MOVE LINE and then release it.
*When downshifting, the gear position may jump up momentarily as the RPM is higher than expected.
The position will begin reading as the bike begins to move in gear
.
FACTORY RESET
In the event you would like to start over with your settings, preferences and display locations, this will reset all settings
back to the out-of-the-box configuration.
This includes message locations, color selections and speedometer calibration but
DOES NOT
include the odometer.
.
.
.
switch unti
switch.
VERSION
For technical support assistance, this screen can display the model number, and the software versions loaded for the two
processors.
EXIT SETUP
Exits the setup menu and returns to normal gauge operation.
