MAN #650776
10
SPEED Speed setup menu
>> Speed calibration requires hold both function switches after the engine is running <<
When >SPEED
, hold
.
ADJUST
,
SERVICE RESET
ODO PRESET or
Press and release the switch to change the selection. Press and hold the switch to select it.
ADJUST Selection
This requires riding a known speed with a GPS, or following another vehicle at a known speed.
ADJUST
, press and hold the switch u
displayed - release the switch.
The
FASTER
SLOWER , to adjust the speed.
.
s displayed to begin adjusting.
When riding a known speed, the speedometer will display a speed reading.
Tap the left switch to adjust speed up. Tap the right switch to adjust the speed down.
isplayed, release the switch.
process until correct.
Exit setup.
AUTO Selection
This requires riding a one mile (or kilometer) distance, which must be determined before starting.
displayed,
The display will sho
You should be at the beginning of your measured distance to ride.
tch.
When
o
The PPM numbers will increase while riding. If they remain at 000000 please check your speed sensor wiring.
When you reach the end of the distance, press and release the switch.
Exit setup.
UNIT MPH / km/h Selection
It is very important to set the speed unit PRIOR to setting the odometer!
UNIT
release the switch.
The display will show UNIT and
MPH for miles and km/h for kilometers.
MPH is default. Press and release the switch to choose between MPH or km/h.
.
SERVICE RESET
miles or km to next service setup
Service is a countdown odometer. The service odometer display can be disabled or can be set to count down from 500
7500 miles, (800 to 12,000 kilometers). If the service odometer is enabled and display reaches 0 miles/km, it will display
ch time the key is turned on.
When
s displayed, pr
played and release the switch.
The current setting will be displayed. The default is
it could be a value in miles or kilometers.
The miles begin at 500 and go up to 7,500 miles in 500 mile increments.
The kilometers begin at 800 and go up to 12,000 KM in 800km increments.
To change the service odometer, press and release the switch until the desired setting is displayed.
Hold the switch until
Exit setup.
PRESET ODO
Odometer preset
The odometer starts at zero, but can be preset by the customer within the first 100 miles (161 km) of riding.
After riding more than 100 miles (161 km), the menu option will no longer be displayed.
Correctly select the units to be either MPH or km/h
FIRST
, as the odometer will be set in the selected units.
The preset is in full miles or kilometers only,
no
tenths.
The odometer preset can be reset multiple times within the first 100 miles (161 km) of riding.
When
pr
displayed and release the switch.
The current miles will be displayed with the left most digit flashing.
To change the flashing number, press and release the switch to the desired number.
, then release the switch.
Repeat the process of until the right most digit has been set.
With the far right number flashing, press and hold the switch and the display will show >
Verify the small odometer at the bottom is what you want set.
o
If incorr
.
o
You can now step through the process again and correct your readings.
o
Turning the key off at any time will discard any attempted odometer settings.
If the odometer is correct at the
the switch to change the display to
ODO?
.
When >
is displayed, press and hold the switch
elease the switch.
Exit setup.
