MAN #650776
11
TACH Tachometer warning setup
When >TACH
, and release.
The selectable options are
HIGH
, DISPLAY
.
Press and release the switch to change the selection; press and hold the switch to select it.
INPUT Signal input setup
This may be required to be changed for some low voltage ECM tach signals.
, release the switch.
The selections are
,
Press and release the switch to change the selection: press and hold the switch to select it.
CYLINDER Cylinder count setup
When >
is displayed, press and
, and release.
The cylinder options range from 1 to 16.
Press and release the switch to change the cylinder count.
Exit setup.
TYPE Signal type setup
When >TYPE s displayed,
is displayed, and release.
The options are
.
Press and release the switch to change the voltage input range.
Press and hold the switch
, and release.
Exit setup.
High warning (shift light) setup
When >HIGH
is displayed,
, and release.
The display will show the current high RPM warning with a *.
The default is 5,500 RPMs but is selectable from 2,200 to 8,200 RPMs.
Press and release the switch to change the RPM warning point.
P
, and release.
DISPLAY setup
When >DISPLAY is displayed, pr
, and release.
The display will show DIGITAL , BAR AND BACK as selectable options.
Press and release the switch to change the how the tach reading is displayed.
P
, and release.
Exit setup.
OIL TEMP Engine oil temperature setup menu
Only valid to use when optional SEN-1043 or SEN-1044 is used.
When >OIL TEMP
Press and release to choose an option, then press and hold to select option.
When >UNIT is displayed, press and hold the switch
, and release.
Press and release the switch to s
BACK
Press and hold the switch on the selection, until
is displayed, and release.
.
To enable oil temp, when >
is displayed, press and hold the
, and release.
The selections will be
WARNING
TEST
BACK
Press and release the switch to change the selection, press and hold the switch to select it.
SENDER Temperature sender selection
When >SENDER
, and release.
The display options are SEN-1043 SEN-1044
.
Press and release the switch to match to the optional sender you purchased from Dakota Digital.
Press and hold the switch on the selection,
, and release.
HIGH WARNING High oil temperature warning setup
When >
displayed,
, and release.
The display will show th
.
The high temperature warning points range from 225 to 375F, (107 to 190C).
Press and release the switch to change the change the high temp warning point.
Press
, and release.
TEST Resistance test
When >TEST
displayed, and release.
The display will give a resistance (ohm) reading of the sender. An open will read OPEN ..
Press and release the switch to change the gauge. Press and hold the switch to exit.
Exit setup.
