Oil Pressure
Most engines have an oil pressure port on the engine block or near the oil filter
require a separate extension or angled fitting
cooler line, application permitting.
For LSx based engines, you may drill and tap the cast
sensor. Alternatively, use the supplied 1/8” npt >
near the driver’s side rear of the engine behind the intake manifold.
Water Temperature
Typical mounting locations for the water temp
manifold. When installing the temperature sensor, use caution
excessive exhaust heat from damaging the sensor
Drill / Tap here for
1/8”-27 NPT. Drill
size of 11/32”
On the rear of a Small Block
Chevy (with use of an
additional extension)
Sensor installed in
intake manifold
Most engines have an oil pressure port on the engine block or near the oil filter assembly
separate extension or angled fitting for proper sensor clearance. You ma
you may drill and tap the cast metal assembly above the oil filter t
use the supplied 1/8” npt > 16mm adaptor and replace the stock pressure sensor located
side rear of the engine behind the intake manifold.
for the water temperature sensor are the engine block, cylinder head, or intake
When installing the temperature sensor, use caution when selecting a mounting location to avoid
ng the sensor.
On the rear of a Small Block
Chevy (with use of an
additional extension)
Sensor T’d into oil cooler
line (with inline adaptor
purchased separately)
MAN#650311
assembly. Some locations may
You may also “T” this fitting into an oil
above the oil filter to accept the 1/8” npt
6mm adaptor and replace the stock pressure sensor located
the engine block, cylinder head, or intake
when selecting a mounting location to avoid
Sensor installed on
oil filter assembly
Sensor installed in
coolant housing