Speed Sensor
Installation of the speed sensor is generally straight
then simply tighten the new sensor in place making sure that t
the existing speedometer gear. The sensor will thread directly onto a standard GM transmission speedometer
gear that has 7/8”-18 threads.
Connect the harness until it “clips” into place
harness connector while pressing it onto the sensor
connector body in only one direction.
Ford Adaptor Cable (Included in Certain
First, remove the stock gear from the end of the original speedo
is removed, install it onto the new Ford adaptor cable
the original attachment screw, making
transmission. Finally, thread the new speed sensor onto the
Original speed sensor removed from
Gear installed on new Ford adaptor
If you are using an electronic speed sensor
speed output (VSS), the speed sensor supplied in this kit
directly to the SPD SND terminal on the
of the speed sensor is generally straightforward. Remove the cable from the transmission if
then simply tighten the new sensor in place making sure that the square drive shaft on the sensor engages into
the existing speedometer gear. The sensor will thread directly onto a standard GM transmission speedometer
Connect the harness until it “clips” into place. You may need to depress the silver wire
onto the sensor to lock it in place. The harness is indexed to fit the
connector body in only one direction.
Cable (Included in Certain Model Applications)
remove the stock gear from the end of the original speedometer cable or pulse generator. Once the gear
Ford adaptor cable. Secure the new Ford adaptor to the trans
, making certain the gears on the adaptor correspond with the mating gears on the
the new speed sensor onto the Ford adaptor cable.
speed sensor removed from transmission Gear and clip removed
Gear installed on new Ford adaptor
New sensor installed on adaptor
an electronic speed sensor installed in the transmission or have an
the speed sensor supplied in this kit will not be used. Instead, route
terminal on the control module.
MAN#650311
forward. Remove the cable from the transmission if present,
he square drive shaft on the sensor engages into
the existing speedometer gear. The sensor will thread directly onto a standard GM transmission speedometer
to depress the silver wire locking clip on the
The harness is indexed to fit the
meter cable or pulse generator. Once the gear
ord adaptor to the transmission using
correspond with the mating gears on the
.
Gear and clip removed
New sensor installed on adaptor
or have an ECM that provides a vehicle
Instead, route the speed signal
