Dake Corporation
724 Robbins Road
Grand Haven, MI 49417
www.dakecorp.com
9
REV022019
Vice adjustment for angled cuts:
Cuts
≤
20°
For this angle range the bottom most bolt hole needs to be lined up with the leftmost hole in the
bed and the C bolt should be in the bottom slot in the right vice jaw.
1) Using an adjustable wrench loosen all of the bolts.
2) Slide the right vice jaw to the desired angle using the gauge near the top of the vice then
tighten Bolts C and D.
3) Slide the left jaw of the vice to meet the right to match the angle, then tighten bolts A and
B.
4) The left jaw can then be operated as a quick vise again.
20°
≤
Cuts
≤
45°
For angles bigger than 20 coming from 0° use the same steps as above but the top most bolt
hole in the right jaw should be in line with the leftmost hole in the bed and the C bolt needs to be
in the top slot.
To remove bolt C, loosen the nut and reach under the bed of the vice to secure the bolt before
removing the nut completely. Figure below displays the 45° set up.
