DAITEM 171-21X, Installation Manual

Page: 3 / 8

3
3. Programming
IMPORTANT: during recognition programming, the product to be programmed for use with the control panel does not need to
be placed next to it. In fact, we recommend you place the product at a short distance from the control panel (at least 2 meters
away).
Programming enables the detector to be recognised by the control panel.
2. Programme the device as follows:
1. To programme the detector the control panel must be in installation mode. If it is not, ask the user to press:
then
“beep, installation
mode”
IMPORTANT: the control panel indicates there is an error by emitting 3 short beeps. When this happens programming
should be carried out again.
Press
*
then # on
the control panel
keypad
Press and hold the “test”
button until the control
panel responds
The control panel waits
for a
group to be chosen
(from 1 to 8)* . Choose the
group by pressing the
corresponding numeral on the
control panel keypad
Choose the type of triggering:
0: immediate
1: delayed
2: combined
Use the control panel keypad
to select the type
The control panel
gives a voice
message to confirm
then to
)
)
)
)
)
10 s max.
“detector X” “group?” “time delay?”
*
to
* according to the
type of control panel
master code
(0000 by default) engineer installer code
(1111 by default)
“beep, detector X,
group Y immediate
(or delayed
or combined)”
• Example: programming of 1st detector allocated to Gr. 2 with immediate triggering.
“beep, detector
1, group 2,
immediate”
)
)
)
)
)
10 s max.
“detector 1” “group?” “time delay?”
then
IMPORTANT: the control panel indicates
there is an error by emitting 3 short
beeps. When this happens programming
should be carried out again.