OPERATION
Daisy Power Auto-Roll Function
You can set the Auto-Roll timer function in either
direction. As the Auto-Roll is a timer, the roller position
and cord length (how much cord is unrolled off the
roller) will affect where the Auto Roll will stop.
The Auto-Roll is programmed on the
‘Tube Motor’
buttons
(forward and reverse on the control
housing or remote control buttons) after pressing for
5 seconds
, with hesitation indicator.
To engage Auto-Roll on the
Tube Motor
, you need to
press then release the button after the hesitation ‘blip’
at 5secs...but before 10secs of holding down either
the directional control button on the unit or the remote
control button.
To stop operation, press any button.
To manually operate roller after Auto-Roll press any
button.
The Auto-Roll has a factory setting of 120 seconds.
To change Auto-Roll run time:
•
start with pool cover in the normal (start) position
on the pool.
•
ensure the control housing ‘asleep’, that is wait over
3 minutes from any button press.
Note:
AC charger MUST be disconnected.
•
ensure the disengage pin is engaged.
You can program using either the remote control or
the buttons on the unit...however using the remote
within a 1 metre distance will give more consistent
results (as it is more generous with the timing of
pressing ‘both buttons at once’)
1. Start by continually pressing the tube motor button
for the whole operation that you want to program
(don’t release the button then press it again), until
the cover has come off to the desired position on
the roller then release the directional button to stop
operation.
2. After releasing the direction button, count to 3.
3. Then press and hold BOTH tube motor direction
buttons at the same time until it buzzes once
(approx. count to 5), then release both buttons.
4. After programming, let the control housing go ‘to
sleep’ (wait over 2 minutes for lights to turn off)
then test operation. If you press a button before the
control housing goes to sleep it will NOT remember
the program just set
5. Test operation.
If using the remote, make sure you are close to the
control housing on your unit to make sure there is no
electrical interference while programming.
If the control housing goes back to sleep or the move
distance is less than 20 seconds the program will not
change, so wind out to desired length, double press,
wind back in again, double press.
To restore Auto-Roll Factory settings:
1. Start with control housing asleep (control housing
goes to sleep after 2 minutes of no operation/
button press).
2. Press and hold BOTH tube motor direction buttons
at the same time until it buzzes twice (approx. count
to 5), then release both buttons.
3. Allow the control housing to go ‘to sleep’ (wait over
2 minutes for lights to turn off) then test operation.
If you press a button before the control housing
goes to sleep it will NOT remember the program
just set (factory reset).
Note:
Control housing won’t go to sleep with AC
plugged in.
