Daikin VRV IV RXYQ TYDN Series, Engineering Data

Page: 52 / 91

EDUS341411-N Installation Manual
Installation of Outdoor Units 53
3P362438-1B
43 3P362438-1B English
NOTE
Play it safe. For protection of the printed circuit board, touch the con-
VTQNDQZECUKPID[JCPFKPQTFGTVQGNKOKPCVGUVCVKEGNGEVTKEKV[HTQO[QWT
body before performing service.
17.3. Service mode operation
Refrigerant recovery operation/vacuuming operation is possible by
applying setting [2-21]. Refer to 13.2. Operating the push buttons and
&+2UYKVEJGUQPVJGNQIKEDQCTFQPRCIG|HQTFGVCKNUJQYVQUGV
mode 2.
When vacuuming/recovery mode is used, check very carefully what
should be vacuumed/recovered before starting. See installation manual
of the indoor unit for more information about vacuuming and recovery.
17.3.1. Vacuuming method
1 When the unit is at standstill, set the unit in [2-21]=1.
2 9JGPEQPƂTOGFVJGKPFQQTCPFQWVFQQTWPKVGZRCPUKQPXCNXGUYKNN
fully open. At that moment the segment display indication=t.01 and
VJGWUGTKPVGTHCEGQHCNNKPFQQTWPKVUKPFKECVG6'56VGUVQRGTCVKQP
and GZVGTPCNEQPVTQNCPFVJGQRGTCVKQPYKNNDGRTQJKDKVGF
3 'XCEWCVGVJGU[UVGOYKVJCXCEWWORWOR
4 Press BS3 to stop vacuuming mode.
17.3.2. Refrigerant recovery operation method
This should be done by a refrigerant reclaimer. Follow the same proce-
dure as for vacuuming method.
18. Caution for refrigerant leaks
18.1. Introduction
The installer and system specialist shall secure safety against
leakage according to local regulations or standards. The following
standards may be applicable if local regulations are not available.
The VRV System, like other air conditioning systems, uses R410A as
TGHTKIGTCPV4#KVUGNHKUCPGPVKTGN[UCHGPQPVQZKEPQPEQODWUVKDNG
refrigerant. Nevertheless care must be taken to ensure that air con-
FKVKQPKPIHCEKNKVKGUCTGKPUVCNNGFKPCTQQOVJCVKUUWHƂEKGPVN[NCTIG6JKU
CUUWTGUVJCVVJGOCZKOWOEQPEGPVTCVKQPNGXGNQHTGHTKIGTCPVICUKUPQV
GZEGGFGFKPVJGWPNKMGN[GXGPVQHOCLQTNGCMKPVJGU[UVGOCPFVJKUKP
accordance to the local applicable regulations and standards.
Maximum concentration level
6JGOCZKOWOEJCTIGQHTGHTKIGTCPVCPFVJGECNEWNCVKQPQHVJGOCZK -
mum concentration of refrigerant is directly related to the humanly
occupied space in to which it could leak.
The unit of measurement of the concentration is lbs./ft.
3 (kg/m 3 ) (the
weight in lbs. (kg) of the refrigerant gas in 1 ft. 3 (1 m 3 ) volume of the
occupied space).
Compliance to the local applicable regulations and standards for the
OCZKOWOCNNQYCDNGEQPEGPVTCVKQPNGXGNKUTGSWKTGF
2
1
1 &KTGEVKQPQHVJGTGHTKIGTCPVƃQY
2
4QQOYJGTGTGHTKIGTCPVNGCMJCUQEEWTTGFQWVƃQYQHCNN
the refrigerant from the system).
Pay special attention to places, such as basements etc., where
refrigerant can stay, since refrigerant is heavier than air.
Procedure for checking maximum concentration
%JGEMVJGOCZKOWOEQPEGPVTCVKQPNGXGNKPCEEQTFCPEGYKVJUVGRUVQ
2 below and take whatever action is necessary to comply.
1 Calculate the amount of refrigerant (lbs. (kg)) charged to each
system separately.
Amount of refrigerant
in a single unit system
(amount of refrigerant
with which the system
is charged before leav-
ing the factory)
+
Additional charging
amount (amount of re-
frigerant added locally
in accordance with the
length or diameter of
the refrigerant piping)
=
Total amount
of refrigerant
NDU|MIKP
the system
NOTE
Where a single refrigerant facility is divided into 2 entirely independent
refrigerant systems then use the amount of refrigerant with which
each separate system is charged.
2 (QNNQYNQECNEQFGTGSWKTGOGPVU#5*4#'#5*4#'
2007).
19. Disposal requirements
Dismantling of the unit, treatment of the refrigerant, of oil and of other
parts must be done in accordance with relevant local and national
legislation.