IM 926-3 • ROOFPAK APPLIED SYSTEMS 56 www.DaikinApplied.com
Preparing Unit for Operation
Adjusting Supply Fan Thrust Restraints
Thrust restraints are provided when housed double-width
fans are mounted on springs. After the spring mounts are
adjusted for level operation when the fan is running, check
the thrust restraints. With the fan off, set the adjustment nuts
so the spring is slightly compressed against the angle bolted
to the fan housing frame. Refer to
. When the fan is
turned on, the fan moves back to a level position and the thrust
restraint spring compresses.
Thrust Restraint Adjustment (with Fan OFF)
1.
Loosen jam nuts “A”, Figure 79, Detail A.
2.
Turn nut “C” until spring cup and washer contact thrust
restraint angle.
3.
Turn nut “B” until spring is compressed by 2 turns of nut
“B”.
4.
Tighten jam nuts “A”.
Figure 79: Thrust Restraint Adjustment
Jam nut
A
Nut
B
Spring clip
Nut
C
Jam nut
A
Washer
Fan bulkhead
Thrust restraint angle
Fan housing frame
See
Detail A
Detail A
Thrust restraint adjustment (with fan off)
1. Loosen jam nuts
A
.
2. Turn nut
C
until spring cup and washer contact thrust restraint angle.
3. Turn nut
B
until spring is compressed by two turns of nut
B
.
4. Tighten jam nuts
A
.
Summary of Contents for RoofPak RCS Series
Page 129: ......