O-UC12-FEB23-3
Page 1
Nomenclature
L
FS
LH
_ S
0200
A
_ X
V1
Power supply,
V1
–
1ph/50Hz/220~240V;
Y1
–
3ph/50Hz/380~415V
Special symbol.
Minor change revision.
Model change revision
Cooler nominal capacity in kW
0200
–
2.0kW
Refrigerant:
P
–
R407C; Q
–
R410A; S
–
R404A
Special specification symbol, usually omitted
Function symbol
LN
–
Medium Temp. evaporator without heater;
LH
–
Low Temp. evaporator with heater
Unit Category:
FS- Indoor Slim Unit
Application Type:
L - Low temperature
Product Features
These evaporator DX units are designed for specific use in small cold rooms at negative temperature -28
o
C to -13
o
C and it is
compatible with multiple refrigerants: R404A, R410A, R507A, R448A and R449A. The design of the unit enables the
maintenance access in ease.
•
The coil is constructed from bare aluminum fins patterned V Wave with fins spacing 5mm, copper bare tubes with nominal
diameter of 10mm. This fins pattern stands out for better performance of air flow and heat transfer.
•
Superheat measurement, air tightness test and vacuuming could be done easily via the provided shredder port 7/16-
20UNF which built into the suction header.
•
D
rain pan fitting ¾” BSP is
supplied loose and must be fitted on site.
•
Galvanized mild steel casing with polyester powder coating.
•
Branded EBM single phase fan 230V/~/50Hz, 4 poles with protection class IP54. Low power consumption and integrate
thermal protection by thermos contacts which ensure reliable protection against thermal overload.
•
An electrical defrost heater is included at the lower portion of the coil, eliminating the needs for the drain pan heater.
•
All the wiring from the motor and heater is terminated at the electrical box mounted externally.
•
This product is only suitable for fixed installation and the fan is blow through coil, which allows the coil to remove the fan
heat.
